Sony XM-GS100 monoblock Class-D car amplifier box showing 330W CTA RMS power

Class AB or Class D Car Amplifier? The Real Difference Is Heat, and It Is Biggest at the Volume You Actually Listen At (India 2026)

Ask about Class AB versus Class D at most car audio counters and you will hear a sound argument. Class AB is "warmer", Class D is "efficient but harsh", and the choice is about taste. Our own product listings say something close to this. Some of them even describe Class AB as high efficiency, which it is not.

The difference that actually decides where an amplifier can go in your car is heat. The gap is not biggest at full volume, where most people assume it would be. It is biggest at the moderate volume you drive at every day. This piece uses Texas Instruments' published efficiency figures to show why, then shows what that means for where you mount the amp and how you check a spec sheet.

The short answer

Both classes can drive your speakers well. The difference is how much of the battery's power turns into heat inside the amplifier instead of reaching the speakers. Texas Instruments puts it plainly in an application note:

"Class AB exhibits a theoretical peak efficiency of 78%, and is only 30% - 40% efficient at normal operating levels."
Texas Instruments, AN-1497 Filterless Class D Amplifiers (SNAA034A, revised May 2013)

A Class D amplifier switches its output transistors fully on and off very quickly, using pulse-width modulation, instead of running them partly on the way a Class AB does. Very little power is lost in a transistor that is fully on or fully off. That is where Class D's efficiency comes from, and it stays high across most of the volume range.

Why the gap is widest at everyday volume

In the same note, TI compares one of its small Class D chips with a similar Class AB amplifier at two output levels:

Output level Class D efficiency Class AB efficiency
Peak output 88% 75%
Nominal output, well below peak 85% 44%

At full power the two are only 13 points apart. Turn it down to a normal level and Class AB efficiency falls to about half of Class D's. TI's example is a small portable amplifier, not a car amp, so treat the exact percentages as illustrative. TI's automotive paper on the same subject shows the same pattern for car audio. Its chart of efficiency against output power has the Class AB curve falling well below the Class D curve at low and medium output, and it calls Class AB "drastically less efficient than the newer but well-established Class-D switching technology".

Here is what that means in watts. The table below assumes an amp delivering two different amounts of power to the speakers and applies TI's efficiency figures at each level. It is arithmetic, not a measurement of any particular amplifier.

Power reaching the speakers Class AB: drawn / turned into heat Class D: drawn / turned into heat
40 W, a moderate level well below the amp's maximum (efficiency 44% AB, 85% D) 91 W / 51 W 47 W / 7 W
320 W, a 4 x 80 W amp flat out (efficiency 75% AB, 88% D) 427 W / 107 W 364 W / 44 W

At full power the Class AB amp makes roughly 2.4 times the heat of the Class D. At the everyday level it makes about seven times as much. Even at moderate volume, the Class AB amp in this example is putting more power into its heatsink than into your speakers.

That heat is the real question, because most people listen at moderate volume for hours. TI's automotive paper makes the same point: "Class-AB efficiency loss leads directly to additional internal heat generation, which then requires dissipation outside the audio amplifier." That is why a Class AB amplifier has a large finned heatsink, and why it needs air moving over it.

What this means in an Indian car

An amplifier does not start from a cool room. In our jump starter post we cited a 2018 Arizona State University and UC San Diego study that measured cabin air at 46.7°C after a parked car spent an hour in the sun. An amp mounted under a seat or in a closed boot starts the drive from that kind of temperature and then adds its own heat on top.

The makers are clear about where amplifiers should not go. Kenwood's manual for the KAC-PS4D, which Kenwood calls a four-channel digital power amplifier, says:

"Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged." It also lists places to avoid, including "a place that gets hot", "a place that gets direct sunlight" and "a location that gets hit by hot air", and says "Install this unit in a location which allows heat to easily dissipate. Once installed, do not place any object on top of the unit."
Kenwood KAC-X4R / KAC-PS4D instruction manual

That is a digital, switching amplifier, the efficient kind, and the warning still applies. A Class AB amp in the same spot, making several times the heat at the same volume, has even less margin. When an amp gets too hot, its protection circuit shuts it down. You hear the music cut out after half an hour on a warm afternoon and come back once things cool down. If that is happening to you, our post on protect mode covers the other causes to rule out first.

Practically:

  • Under a seat or in a tight space: Class D. The small size is not just convenience, it reflects how little heat there is to get rid of.
  • Under the boot floor, in the spare wheel well, or covered by boot carpet: neither class, unless the space is properly ventilated. Kenwood's carpet warning applies to both.
  • On an open, ventilated rack or panel in the boot: either class works. This is where a Class AB amp belongs.

Heat is also current. Every watt the amp wastes comes from your alternator while driving, and from your battery when the engine is off. In the example above, the Class AB amp at moderate volume draws roughly twice the power of the Class D for the same sound. If you sit in traffic with the music on, or play music with the engine off, that difference reaches your battery. Our battery drain guide covers what else draws on it.

Read the spec sheet with the class in mind

Our post on the PMPO watt lie gives a quick ceiling check: fuse amps, times 12 volts, times efficiency, gives the most real power an amp can deliver. That post uses a 60 to 85 per cent efficiency range. That range is right for amps near full power. It is too generous for a Class AB amp at normal listening levels, where TI's figures fall to 30 to 44 per cent. The fuse check still sets the ceiling. The class tells you how much of that ceiling ends up as heat.

Two examples from our own catalogue:

  • Nakamichi NKTE80.4 (Class AB). The box says Class AB four-channel. Overseas retailers list it at 80 W RMS x 4 at 4 ohms with two 25 A fuses. Our own listing states neither number, which we will fix. Two 25 A fuses at 12 V allow about 600 W in. A Class AB amp making 320 W at full power needs about 427 W in at TI's 75 per cent figure. The rating is believable.
  • MARTS MAB 480.4 (Class AB). Our listing's title says 4 x 240 W RMS at 4 ohms, but its own description says 4 x 120 W at 4 ohms and 4 x 240 W at 2 ohms. Even taking the 2 ohm figure, 960 W of Class AB output at 75 per cent efficiency needs about 1,280 W in. That is well over 100 A at 12 V. The listing does not state a fuse rating. Ask us for it before you buy. If the fuses on the unit cannot carry that current, the rating cannot be real.

The general rule: for any amp, ask for the RMS figure at 4 ohms and the fuse rating. If you are buying Class AB, also ask yourself where the heat will go.

Does Class AB sound better?

This is the claim we cannot settle with data. We have not run blind listening tests, and we are not going to pretend we have. Here is what the evidence does show. TI's automotive paper notes that car radios have traditionally used Class AB. It then describes designers moving to Class D, which it calls "well-established", to cut heat and size. Class D is not a budget compromise.

Our view: at the prices we sell, how the system is set up matters far more than the amplifier class. That means the speakers, the install, and especially the gain setting. A Class AB amp with the gain set wrong will sound worse than a Class D amp set up properly. If you have not read it, our gain and clipping guide is worth more to your sound than this whole debate. If you want to tune the soundstage too, a DSP amplifier changes more than the output stage does.

If you like the Class AB sound and have a ventilated place to mount it, buy one. Just choose it knowing about the heat, not because of the "high efficiency" claim. That includes the claim on some of our own listings.

What we would pick

Your situation Class From our range
Amp has to go under a seat or behind a panel Class D myTVS DMP-4, Rs.6,990; Blaupunkt PDx 4.120D PRO, Rs.10,999
Two channels for a front speaker pair Class D Infinity Primus 8002A, Rs.8,500
A subwoofer amp Class D Sony XM-GS100, Rs.19,999 (330 W RMS on the box)
Ventilated boot mount, and you prefer Class AB Class AB Nakamichi NKTE80.4, Rs.8,990; AURA Fireball 4.101, Rs.10,999

For bass in particular, Class D is the clear choice. Subwoofer amps work hardest and produce the most power, so efficiency matters most there.

Not sure where an amp can go in your car? Bring it to our JC Road counter in Bengaluru and we will look at the mounting space with you before you choose.

Last fact-checked 19 November 2026. Sources: Texas Instruments AN-1497 (SNAA034A); Texas Instruments, "Automotive Audio Design Considerations to Minimize Amplifier Size and Thermal Load" (SLYY179, 2019); Kenwood KAC-X4R / KAC-PS4D instruction manual; Vanos et al., Temperature, 2018; manufacturer packaging for the Sony XM-GS100 and Nakamichi NKTE80.4. Worked figures are arithmetic using TI's published efficiencies, not measurements of specific amplifiers.

Related Posts

Your Phone Holder Is Legal in One Place Only: What India's 2020 Navigation Rule Actually Says, and Where Your Airbags Say It Cannot Go (2026)

Most advice about phone holders, including some on this blog, goes like this: holding your phone while driving gets you a Rs.5,000 challan, so...
Post by ExactWhy
Nov 19 2026

Your Car Manual Says Put Nothing Under the Front Seat. When an Underseat Subwoofer Still Fits Safely (India 2026)

An underseat subwoofer is sold on one promise: bass without giving up the boot. Then you open your car's owner's manual and find a...
Post by ExactWhy
Nov 19 2026

Water Inside Your Headlight After Fitting LED Bulbs? The 30-Minute Test, the Dust Cap Nobody Checks, and Why IP68 on the Box Is Not About Your Headlamp (India 2026)

The northeast monsoon set in on 15 October over Tamil Nadu, coastal Andhra Pradesh, Rayalaseema, Kerala and south interior Karnataka, which takes in Bengaluru....
Post by ExactWhy
Oct 26 2026

A Diwali Rocket Melts Your Bumper and Insurance Covers It, but Claiming Can Cost More Than Paying: Plastic Depreciation, NCB and the Rs.500 Rule (India 2026)

Short answer: if a firecracker burns or melts part of your car, a comprehensive policy covers it. Fire and explosion are both on the...
Post by ExactWhy
Oct 24 2026

The Laser in a Laser Fog Lamp Only Works in the Mode You Should Not Use in Fog: Reading the Box Before Fog Season (India 2026)

Short answer: on the "laser" fog lamps we sell, the laser part only helps the high beam. Our own product listings say so. In...
Post by ExactWhy
Oct 23 2026

Before You Post That Dash Cam Clip: What Indian Law Actually Covers in 2026, Why the Caption Is the Risk, and What the Video Reveals About You

You caught it on camera. A car jumped the signal, cut across three lanes, or a driver got out and started shouting at your...
Post by ExactWhy
Oct 15 2026

Your Dash Cam's Speed Stamp Is a Witness That Does Not Pick Sides: GPS Speed, the 5 Per Cent Rule and Contributory Negligence (India 2026)

Most GPS dash cams write your speed into the corner of every frame. Shops sell that as protection, and our own product listings call...
Post by ExactWhy
Oct 13 2026